How to restart the port

Start the Port 

Push the Power button to start the Port. Note that it can take up to several minutes until the Port is operational. If the Port has been turned off for a longer time, it needs up to 15 minutes to charge up the belt driver before it is ready to use. 

Press the Retry button if the port has been powercycled due to an error message.

NOTE

Leave the port to charge up the belt driver for at least 15 minutes after powering it on.

Shut down the Port

Push and hold the "Power" button for 5 seconds to shut down the Port Controller.

NOTE

The Port Controller’s emergency stop disables only one port; it does not stop the entire system. 

Related articles

How to use the buttons in port control panel
How to stop the system in Customer console
Stop the system using the Emergency stop button

Was this article helpful?
1 out of 1 found this helpful

Articles in this section