How to use the buttons in port control panel

There are three buttons on the port control panel that allow Pio Users to control the port as follows:

Power button

To start the port, push the power button.

If you want to shut down the port, push and hold the power button for 5 seconds.   


Port "Retry" button

Push the "Retry" button to repeat an action that has previously failed; e.g. bin didn't return into the grid.


Emergency stop

In the event of an emergency, press the "Emergency Stop" button located on the right-hand side of the control panel.

Please note that the "Emergency Stop" button on the control panel only stops the specific port it is connected to. Other ports and the rest of the Pio system will continue to operate normally.


Was this article helpful?
0 out of 0 found this helpful

Articles in this section